Powered by Blogger

Subscribe to
Posts [Atom]





Quality Water Filters 4 You Posting Page
Tuesday, April 12, 2011
Do you have bluish green stains in your shower, bath, or under a faucet? If so, you need to read this short article as this water condition can affect the health of your family.

In simple terms, blue-green stains happen when two conditions are met. The first is water that is corrosive is entering the house or being generated by the plumbing inside the house. The second condition is having copper plumbing inside the home or office.

Copper is often found in plumbing and plumbing fittings. When copper comes into contact with corrosive water it forms copper oxide. This copper oxide is what causes the distinctive blue-green color of the stains. If your stains are brownish or orange, the problem is most likely iron oxide.

Not all areas of the country have naturally occurring corrosive water. However, some areas, such in the Northeast, do. For instance, much of the water found in New Hampshire is corrosive.

Corrosive water will also hurt pipes by eating small holes in them which result in leaks.

The best way to treat this type of water is to increase the pH of the water before it enters the home or office or just after it enters. Increasing the pH will lower the corrosive nature of the water. A higher pH will also help to alleviate any iron corrosion problems you may have.

In addition to hurt pipes and staining fixtures, low-pH water can also affect the health of those who drink it or consume it through cooking. Water that is corrosive in nature can also cause lead, copper, rust, cadmium and zinc to leech into your drinking water at higher than safe levels.

You can buy an easy to use pH test kit and test your tap water. If the pH is below 6.0 it is definitely corrosive and should be treated as soon as possible. A pH reading of between 6.0 and 7.0 indicates your water is somewhat corrosive and should be treated as well.

Whole house water filtration units are available to help prevent corrosive water. If you water comes from a municipal water company, you should contact them and have them assist you in getting a higher pH at your home or office. For those who get their water from private wells or other private sources, consulting with a qualified water filter vendor is in order. These professionals can help you understand the problem and offer viable solutions that will take care of this unsightly and dangerous problem.




Bookmark and Share


by: Chris Tracey

0 Comments:

Post a Comment

Subscribe to Post Comments [Atom]

Links to this post:

Create a Link